The cooling or heating effect produced during summer or winter is backed up by proper air conditioner maintenance or a heat pump system. The condenser unit which is located outside the house usually on a solid slab, and the evaporator coil over the heater are the two separate components of central air conditioners.
With that, you can carry out maintenance on an AC by simply removing any form of blockage from the fan and the airflow of the condenser. This is because when the AC is working the condenser unit turns down the heat to its environment by the condensing oils being blown over by the fan.
Similarly, the few steps listed in this article are very simple to follow, and most importantly you would not need a technology expert to help you in carrying them out. Be equipped and get some tips from this article, it would be useful to you in the long run.
5 Step By Step Method To Maintain An AC
1. Power Turn Off
When you turn off your ac, it runs for only a short period and that means less damage to your system. Also, few technicians recommend turning off the AC when not in use.
You can find the switch at the power button located close to the exterior condenser unit or by turning off the power at the breaker box. Be aware that the power of the switch near the condenser is present in essentially most air conditioners.
Note this fact, AC continues to consume electricity until it has been switched off. Do not switch off the ac when not in use make sure it is not by any means consuming more electricity.
2. Take Out Wreckage
When taking out the wreckage or debris, the first thing you need to do is to examine your AC unit carefully. If you notice any leaves or any dirt clustered that could be easily removed, take them off by using your hands.
After that, you can smoothly spray off the outer unit. Or you can also detach the fan cage and you either your bare hands or a damp or dry cloth or brush to brush off or remove the debris, cobwebs, dirt, or leaves from the interior and areas with large lint buildup.
3. Clean The Fins
Condenser fins and evaporator fins are the two types of air conditioner fins. They function in a similar manner but each in its peculiar way allows the entry and removal of air from the air conditioner to flow smoothly.
To clean the fins, take out the outer covering, and by using the brush attachment on a strong shop vacuum clean all the outside dirt. After you have done that, spray the fins inside out to remove all debris or dirt built up between the fins using a gentle stream from a garden spray.
4. Clean the evaporator coil
You can clean the evaporator coil in several ways, to clean the inside of the evaporator coil simply use a soft brush to dust off dirt on the coil. Then use a no-rinse coil cleaner to spray the coil. The coil cleaner spray will foam up and eventually drip into the drain pan.
You can clean out the drain pan by using either bar soap, warm water, or bleach. You can make your coil cleaner by mixing simple detergent or bar soap and look-warm water in a garden spray bottle.
Then spray the DIY solution on the evaporator coil, and let it soak in for at least five minutes. Be sure to wipe out loosened particles with a soft brush or a damped cloth. One of the easiest procedures to clean the evaporator is by using a compressed air canister.
5. Clean Evaporator Drain
The best recommendation for cleaning an evaporator drain of an AC is by using vinegar in place of a bleached solution. If your AC system drain line has copper tubing, don’t use a bleach solution.
An air conditioner has an evaporator drain line that operates from the interior unit to the exterior unit in the house. Located near the exterior unit is the copper pipe where the drain line stops.
Flooding on the floor can be caused by a plugged drain. It also causes low cooling of the system if the system is equipped with a drain float to avoid flooding.
